UNIPLAN smoothing compound is suitable for thin finishing on:
- old adhesive residues
- renovated fibreboard
- wooden stairs
- old floor tiles
- cement screeds
- for restoring stair risers.
It can be applied in layers between 0.5 and 2 mm thickness. For interior use only.
Physical:
- Composition: Synthetic paste
- Colour: Grey
- Working temperature : Preferably between +10°C and +30°C.
- Drying time: 12 to 24 hours at +20°C
- Frost sensitive
- Resistant to castor wheels
Consumption:
1.6 kg/m² per 1 mm thickness.
Safety:
IMPORTANT: before embarking on any work involving UNIPLAN the separate Product Safety Data Sheet must be studied carefully by those carrying out the work.
Shelf life:
Up to 9 months in the original unopened container, stored between 10° and 30°C. Frost sensitive.
PREPARATION
Subfloors must be sound, of adequate tensile and compressive strength; free from laitance, cracks and structural defects; clean and free from dust, grease, curing compounds, sealers or any other contaminants that would inhibit proper bond.
Substrate residual moisture content must be less than 3%. If not, use Eponal 336 Damp Proof Primer.
Adhesive residues that are hard, sound and water-tight should be mechanically cut-back to a minimum. Soft and weak adhesive residues and smoothing underlayments should be completely removed.
APPLICATION
Mix by stirring immediately before use.
Ready-to-use product – Do not add water.
The smoothing and levelling compound must be applied to the substrate and smoothed with a stainless steel float. Spread the compound to zero in order to fill the pores, then smooth and spread in a regular manner to the desired thickness.
Protect from excessively rapid drying, e.g. due to direct sunlight, draught or high room temperature. Conversely, poor airflow and low temperatures will significantly increase drying times. Do not lay floor coverings until the compound is completely dry.
CLEANING
Clean fresh splashes and tools with water.
Tiling
Waterproofing coatings
(1)
